Add HackerComms

flash.sh

Add to radio

Connect your Meshtastic radio. This page reads its channel slots, puts HackerComms in the first empty one, and leaves every other channel and setting alone. Nothing is sent anywhere but your radio.

/dev/radio Idle

Channel slots appear here after you connect.

write.planone slot only

nameHackerComms

psk6IzsaoVhx1ETWeWuu0dUWMLqItvYJLbRzwgTAKCfvtY=

rolesecondary # first empty slot

untouchedPrimary channel, other channels, LoRa & device config

phone.txtMeshtastic app

Scan with the Meshtastic app. This link is in add mode, so recent app versions append the channel instead of replacing yours — check the app's prompt before you confirm.

Troubleshooting

No port listed? Install your board's USB driver (CP210x or CH9102) and close the Meshtastic app or any serial monitor using the port. Bluetooth asks for the PIN shown on the radio's screen (default 123456 on boards without one).